EC600 V2.0 4/10
4
Keypad Description
The meter has five (5) front panel function keys:
ON/OFF Power Key
Calibration Key:
a) When taking a measurement, press this key to enter the calibration mode
b) When in the programming mode, press this key to change the displayed
number or the ON/OFF state
Function Key
a) In pH measuring mode, one short press switches between pH and mV
measuring modes. One long press (>2s) enters the parameter setting mode.
Subsequent presses will scroll through the available parameters.
b) In other measuring modes, press and hold to enter the parameter setting
modes. The meter will scroll through the available parameters
Backlight and ENTER Key
a) In the measurement mode, momentary presses toggle the backlight on and off
b) When in the programming or calibration mode, press to ENTER data
c) When in the pH mode, press and hold to change the resolution in the range of
0.01 to 0.1pH
d) When in the Conductivity mode, press and hold to scroll through the TDS,
Salinity, Resistivity, and Conductivity modes
MEMORY STORE and RECALL Key
a) In the measurement mode, momentary presses store the displayed readings.
Press and hold for at least 2 seconds to recall a saved reading
b) In programming mode, press to change the displayed number or ON/OFF state
Store, Recall, and Clear Datalogger Memory
STORE Readings
The meter can store up to 100 pH, 100 mV, and 100 Conductivity readings for a total of
300 data points. To store a reading, wait until the reading stabilizes (the smiling face icon
appears when the reading stabilizes). Press the
M+/RM
key momentarily to store a
reading. The
M+
icon appears and the data point serial number increments.
RECALL Readings
In the measurement mode, press the
M+/RM
key to recall the most recently stored
reading.
RM
and the data point serial number for the displayed reading will appear on the
LCD. The measurement information will appear on the lower right hand side of the LCD.
Use the
CAL
or
M+/RM
buttons to scroll the remaining stored readings. Press the
ENTER
key to return to the normal measurement mode.
CLEAR Readings
From the RECALL mode, press and hold the
ENTER
key for at least five (5) seconds. The
LCD display will show ‘CLR’ indicating that all of the stored readings have been erased.
www.burntec.com
www.burntec.com
