42535 Version 4.0 01/05
2
Meter Description
1. LCD
Display
2. Emissivity
button
3. Down
button/°F°C
4. Mode
button
5. Up
button/Lock
6. Battery
cover
7. Infrared
lens
8. Laser
pointer
9. Measuring
trigger
10. Thermocouple
input
Operating Instructions
Infrared Temperature
1.
Point the meter toward the surface to be measured.
2.
Pull and hold the trigger to turn the meter on and begin testing. “
SCAN
” and a blinking
icon will appear in the display while the trigger is held.
3.
Release the trigger and “
HOLD
” will appear. The last reading will remain in the display
for 60 seconds and then the meter will shut off.
4.
While measuring, press the
ºC/ºF
button to turn the laser pointer on or off. When the
laser is on, the icon will appear on the top left of the display.
5.
While in the HOLD mode, press the
ºC/ºF
button to change the temperature units.
6.
Momentarily press the
Mode
button to step through and view the
MAX
(maximum),
MIN
(minimum),
dIF
(difference between the max and min),
AVG
(average),
HAL
(high
alarm),
LAL
(low alarm),
PRB
(type k probe) or
E
(emissivity).
7.
While in the HOLD mode, momentarily press the
LOCK
button to allow the meter to run
continuously for 60 minutes without holding the trigger. The “
LOCK
” and “
SCAN
” icons
will appear in the display. Press the
LOCK
button again to exit Lock mode.
0.5
1.0
2.0
5.5
11
22
Diameter of Spot (inches)
Distance to Object (inches)
Laser Pointer
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
FAX 781.665.0780 - TestEquipmentDepot.com
