13
EX
-
1189HMVS
-
3W
English
6. Cleaning
4. Hardware Installation
Because there are large differences between PC
’
s, we can give you only a general in-
stallation guide. Please refer your computer
’
s reference manual whenever in doubt.
1.
Connect the USB cable to the USB B
-
Port at the Hub.
2.
Connect the included power supply to the DC connector at the hub or connect the
optional power supply into the terminal block at the Hub.
3.
Now connect the other end from the USB cable (A
-
Plug) to the A
-
Port at your PC.
5. Driver Installation
All Operating Systems
After the hardware installation the OS will recognize the device automatically and install
the drivers.
CHECK INSTALLED DRIVER
Open the >
Device manager
<. Now you should see at
„
USB
-
Controller
“
the following
new entry's:
If you see this or a similar information the device is installed correctly.
For cleaning please use only a dry fluff less cloth and remove the dirt with gently pres-
sure. In the area of the connectors please make sure that no fibres from the cloth re-
main in the connectors.
Attention! Never use a moist or wet cloth for cleaning!
© Copyright 2018 by EXSYS Vertriebs GmbH. All Rights Reserved
