12
English
EX
-
1179HMVS
© Copyright 2020 by EXSYS Vertriebs GmbH. All Rights Reserved
4. Hardware Installation
Because there are large differences between PC
’
s, we can give you only a general in-
stallation guide. Please refer your computer
’
s reference manual whenever in doubt.
1.
Connect the USB cable to the USB B
-
Port at the Hub.
2.
Connect the optional power supply into the terminal block at the Hub.
•
The push
-
in mechanism of the Terminal Block allows you to push the wire
directly into the contact hole and automatically lock it by its internal latching
spring.
•
To remove the wire, you will need a tool (such as a small flat
-
bladed
screwdriver) to release the internal locking spring and remove the wire as
shown in the following figure. If the wire is too soft to be inserted into the
contact hole, you will need to loosen the locking cord with the above tool,
insert the wire and then release the locking spring to lock the wire.
3.
Now connect the other end from the USB cable (A
-
Plug) to the A
-
Port at your PC.
4.
Finally, you can now install the EX
-
1179HMVS on the wall or on a DIN
-
Rail (see fol-
lowing picture).