11
Operating Instructions (continued)
Turning Off
1 . Turn gas cylinder valve to “CLOSED .”
2 . Turn all control knobs clockwise to the
•
(OFF) position .
Note: A “poof” sound is normal as the last of the LP gas is burned .
3 . Disconnect gas cylinder per “Disconnecting Gas Cylinder” section .
.
WARNING
W
When cooking, fire extinguishing materials
should be readily accessible. In the event of
an oil/grease fire, use type BC dry chemical
fire extinguisher or smother with dirt, sand
or baking soda. Do NOT attempt to extinguish
with water.
Controlling Flare-ups
1. If a grease fire develops, turn control knobs to the
•
(OFF) position and Gas cylinder valve “CLOSED.” Do NOT use water
on a grease fire. This can cause the grease to splatter and could result in serious burns, bodily harm or other damage.
2. Do NOT leave grill unattended while preheating or burning off food residue on (HIGH). If grill has not been cleaned, a
grease fire can occur.
Flare-ups are a part of cooking meats on a grill and add to the unique flavor of grilling .
Excessive flare-ups can over-cook your food and be dangerous.
Important:
Excessive flare-ups result from the build-up of grease in the bottom of your grill .
If a grease fire occurs
, close the lid
AND
turn the control knob(s) to
•
(OFF) until the grease burns out . Be careful when
opening the lid as sudden flare-ups may occur .
If excessive flare-ups occur,
do NOT
pour water onto the flames .
Minimize Flare-ups:
1 . Trim excess fat from meats prior to cooking .
2 . Cook high fat content meats on (LOW) setting or indirectly .
3 . Ensure that your grill is on a hard, level, non-combustible surface and the grease is allowed to drain into grease receptacle .
Cleaning and Care
.
CAUTION
1. All cleaning and maintenance should be done
when grill is cool and with the fuel supply
disconnected.
2. Do NOT clean any grill part in a self-cleaning
oven. The extreme heat will damage the finish.
3. Do NOT enlarge valve orifices or burner ports
when cleaning the valves or burners.
Before Each Use:
1 . Keep the grill area clean and free from any combustible materials, gasoline, and other flammable vapors and liquids .
2 . Do NOT obstruct the flow of the combustion of LP gas and the ventilation of air .
3 . Keep the ventilation opening(s) of the Gas cylinder area free and clear from debris .
4 . Visually check the burner flames to make sure your grill is working properly (Figure 6) .
5 . See sections below for proper cleaning instructions .
6 . Check for obstructions of airflow to the burners . Spiders, insects and webs can clog the burner/venturi tube . A clogged
burner tube can lead to a fire .
Cleaning Surfaces
1 . Wipe surfaces clean with mild dishwashing detergent or baking soda mixed with water .
2 . For stubborn surfaces, use a citrus-based degreaser and a nylon scrubbing brush .
3 . Rinse clean with water .
4 . Allow to air dry .
Cleaning Main Burners
1 . Turn the regulator valve handle counterclockwise into the the “OFF” position (Figure C) .
2 . Turn all control knobs clockwise to the
•
(OFF) position .
Note: A “poof” sound is normal as the last of the gas is burned .
3 . Disconnect gas cylinder per “Disconnecting Gas Cylinder” section .
4 . Remove cooking grids and heat plates .
5 . Remove burners by removing the fasteners, which secure the burners to the grill bottom .
6 . Lift burners up and away from gas valve orifice .
7 . Disconnect wire from spark electrode .
8 . Clean venturi of each burner with small bottle brush or compressed air .
9 . Remove all food residue and dirt on burner surfaces .
10 . Clean any clogged ports with a stiff wire (such as an opened paper clip) .
11 . Inspect burners for any damage (cracks or holes) . If damage is found, replace with new burner(s) from manufacturer .
12 . Reinstall burners, checking to insure that gas valve orifice is correctly positioned inside each burner/venturi tube . Also,
check position of spark electrode .
13 . Replace heat plate(s) and cooking grid(s) .
14 . Connect gas cylinder per “Installing Gas Cylinder” section .
15 . Perform leak test per “Checking for Leaks” section .
Before Storing
1 . Turn the regulator valve handle counterclockwise into the the “OFF” position (Figure C) .
2 . Turn all control knobs clockwise to the
•
(OFF) position .
Note: A “poof” sound is normal as the last of the gas is burned .
3 . Disconnect gas cylinder per “Disconnecting Gas Cylinder” section .
4 . Clean all surfaces .
5 . Lightly coat the burner(s) and cooking grid(s) with cooking oil to prevent excess rusting .
6 . If storing the grill indoors, disconnect the gas cylinder per “Disconnecting Gas Cylinder” section .
7 . Place the protective cap cover on the gas cylinder and store the tank outdoors in a well-ventilated area out of direct
sunlight .
8 . If storing the grill indoors, cover the grill and store in a cool dry place .
9 . If storing the grill outdoors, cover the grill with a grill cover for protection from the weather .
.
1. This grill should be thoroughly cleaned and
inspected on a regular basis.
2. Abrasive cleaners will damage this product.
3. Never use oven cleaner to clean any part of
grill.
NOTICE
Figure 6
Burner Flame Conditions
Use this chart to see if your burners
need to be cleaned .
1-2 in. /
25.4 - 50.8 mm
Normal:
Soft blue flames with yellow
tips between 1 in . - 2 in . height .
Needs cleaning:
Noisy with hard
blue flames .
Has to be replaced:
Wavy with
yellow flames .
