Exmark Z Turf Equipment Z-SWEEP, Руководство оператора

Страница: 11 / 37

Operation
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
Controls
Become familiar with all the controls before starting
the engine and operating the machine.
Choke Control
The choke control is the top lever located on the rear
LH side of the engine above the fuel shut-off valve.
The choke is used to aid in starting a cold engine.
Move the lever left to the “ON” position for a cold
start. Do Not run a warm engine with the choke in
the “ON” position.
Throttle Control
The throttle control is located on the rear RH side
of the engine.
The throttle is used to control engine speed. Moving
the throttle control to the left will increase engine
speed and moving it right will decrease engine speed.
Engine On/Off Switch
Located on the RH side of the engine.
Rotate the switch clockwise to the “ON” position
before starting the engine. Rotate the switch
counterclockwise to the “OFF” position to shutdown
the engine.
Fuel Shut-Off Valve
The fuel shut-off valve is the lower lever located on
the rear LH side of the engine below the choke. The
fuel shut-off valve shuts off the flow of fuel when
the machine will not be used for a few days, when
parking inside a building, and during transport to and
from the job.
Move the lever to the left to shut off fuel. Move the
lever to the right to turn on fuel.
Wheel Clutch Levers
Located below the RH and LH handles.
The wheel clutch levers allow the drive to momentarily
disengage to one or both wheels with the traction
drive lever still engaged. This allows easier turning
and maneuvering the machine (see Figure 4).
Squeezing both wheel clutch levers simultaneously
disengages the drive to both wheels (free-wheeling).
This enables you to manually move the machine
backward without stopping to shift it into a reverse
gear. It also allows you to maneuver and transport the
machine more easily when the engine is not running.
g327245
Figure 4
1. Wheel clutch lever 4. Traction drive lever
2. Handle 5. Speed selector lever
3. Broom angle lever 6. Broom drive lever
Broom Drive Lever
Located above the RH handle (see Figure 4).
To engage the broom, squeeze the lever to the handle.
To disengage the broom, release the RH lever.
Traction Drive Lever
Located above the LH handle (see Figure 4).
The traction drive lever controls the forward and
reverse motion of the machine. To engage the
traction drive, squeeze the lever to the handle.
Note:
Holding down the traction drive lever against
the handle engages the traction drive to both wheels.
Speed Selector Lever
Located on the main console panel (see Figure 4).
The speed selector has six forward and two reverse
settings. To change speeds, release the traction drive
11