Exmark Z Turf Equipment Z-SWEEP, Руководство оператора

Страница: 26 / 37

Maintenance
Check Broom Segments
Service Interval: As required
1. Move the machine to a level surface.
2. Stop engine, wait for all moving parts to stop, and
remove the spark plug wire(s).
3. Raise the broom by resetting the caster positions.
4. On both sides of the machine, remove and retain
the outer bearing housing hardware.
5. Manually pull the power unit rearward to remove
the broom assembly from the unit.
6. Support the splined shaft on either side of the
gearbox.
7. Stand the broom core assembly on end so
removable end retainer plate is facing upward.
g018760
Figure 19
1. Hardware 4. Support shaft
2. End retainer plate 5. Alignment fingers
3. Broom segment
8. Remove and retain the hardware from the end
retainer plate.
9. Remove the damage broom segment(s). Install
the new segment(s) by staggering the metal ring
alignment fingers as shown in Figure 19.
Important:
Damage may occur to the broom
assembly if the broom segments are not
properly installed.
10. Reinstall the broom assembly to the machine.
Important:
Make sure the bearing setscrews
are tightened before operating the broom.
Adjustments
Traction Cable Adjustment
With the traction lever disengaged, check the
clearance between the bottom of the traction cable
bracket and the top plate of the machine. The traction
cable bracket should touch the top plate (reference
Figure 14).
If the left hand (traction) cable is not properly
adjusted, do the following steps:
1. Loosen the jam nut.
g325108
Figure 20
1. Adjuster tube 3. Spring tension adjuster
2. Jam nut
4. Spring
2. Rotate the spring tension adjuster until the cable
is taut and the bottom of the bracket touches the
top plate of the machine.
g326108
Figure 21
3. Tighten the jam nut.
26