Exmark Z Turf Equipment Z-SPRAY, Руководство оператора

Страница: 34 / 68

Operation
Important:
If you used wetable powder
chemicals, clean the strainer after each tank
rinse.
g027118
Figure 20
1. Supply valve 2. Strainer
17. Repeat steps 5 through 16.
18. Using a garden hose, spray off the outside of the
sprayer tank with clean water.
Note:
Do Not use a power washer to clean the
machine. The high pressure water may force
residual corrosive materials into spreader-spreader
components.
19. Remove the nozzles and clean them by hand.
Replace damaged or worn nozzles.
20. Allow the spreader-sprayer to completely dry
before the next use.
Calibrating the Sprayer Flow
Note:
Before using the sprayer for the first time,
change nozzles, or as needed–calibrate the sprayer
flow and speed.
Note:
Refer to the chemical product label for
application rate recommendations.
The method to calibrate the sprayer flow involves
driving a preset distance, recording the time, and then
measuring the amount of liquid applied during that
time.
Determine Spray Width
The wide spray width on this machine is 108 inches
(274 cm) at 40 psi (2.8 bar).
g025854
Figure 21
Top View of Wide Spray Nozzles
1. Distance between nozzles = 26 inches (66 cm)
2. Nozzle
3. Spray angle = 120 degrees
4. Spray width = 108 inches (274 cm)
5. Spray distance = 24 inches (61 cm)
The narrow spray width is 48 inches (122 cm) at 40
psi (2.8 bar).
g025952
Figure 22
Top View of Narrow Spray Nozzle
1. Nozzle
2. Spray angle = 120 degrees
3. Spray width = 48 inches (122 cm)
4. Spray distance = 14 inches (36 cm)
Collecting Nozzle Spray Discharge
Note:
Ensure that there is enough water in the tank
to complete the calibration.
1. Set the parking brake and turn the engine on.
2. Set the pump/tank agitation switch to the “ON”
position.
3. Pull the agitation lever rearward to turn on the
tank agitation.
4. Place the throttle to the “FAST” positions.
5. Push the agitation control lever down to the
“OFF” position.
34