Exmark ULTRACAV LZUV2B, Руководство оператора

Страница: 13 / 24

Operation
then lift it from the mount bracket. The bracket
bolted to the toe board remains on the unit.
WARNING
Caster or toe board weights installed without
the collection system may cause loss of
traction and steering control. Loss of control
can result in an accident which may cause
death, injury, or property damage.
Install caster or toe board weights ONLY
when the collection system is installed.
12. Propane Units: Do Not remove the two factory
installed toe board weights without decals. ONLY
remove the one toe board weight with a decal
on it.
WARNING
Removing the toe board weights from the
propane unit may cause loss of traction and
steering control. Loss of control can result in
an accident which may cause death, injury,
or property damage.
• Do Not remove the two factory installed
toe board weights from the propane unit.
Only remove the third (center) weight.
• Install the third (center) caster weight
ONLY when the collection system is
installed.
13. For the 3-Bagger Units: Remove the caster
weights by loosening the clamping knobs until the
weight can be moved relative to the caster arm.
Remove the hairpins and clevis pins that hold
the weights to the caster arms. Carefully lift the
weights off of the caster arms.
Note:
The removable weights are heavy. Use
care when lifting them. Make sure that you can
hold them securely before lifting them. Use
caution when positioning your hands so that you
Do Not set them down on your hands or fingers.
Note:
The portions of the UltraVac collection
system that are not bolted to the mower are
designed to be installed or removed in their
entirety. Do Not operate the mower with only a
portion of the UltraVac installed.
14. The machine can now be used for side discharge
mowing.
Collection System Installation
Important:
Verify that the reinforced bumpers
are installed on your unit prior to operation.
Important:
Due to the added weight of the
UltraVac, it is important to ensure the parking
brake on your mower is adjusted properly. Before
installing the UltraVac, make sure to re-adjust
the parking brake on your mower as outlined in
the “Adjusting the Parking Brake” procedure in
the Maintenance section of the mower Operator's
manual.
1. Stop engine, remove key, and wait for all moving
parts to stop. Engage parking brake.
2. Remove hairpin and chute pivot pin. Remove
discharge deflector. Pivot pin and hair pin may be
stored in the pivot holes of the discharge deflector
during bagging operation.
3. Lay the hopper assembly down as shown in
Figure 9.
g007986
Figure 9
1. Lower bagger mount bar 2. Frame notch
4. Remove the hairpin from the mount pin and pull
the mount pin out of the frame mount barrel.
5. Pick up the frame legs and hook the notch onto
the lower mount bar (see Figure 9).
6. Lift the hopper assembly and pivot it upward
towards the back of the unit (see Figure 10).
13