neutral lock latches (Figure 7). If the tire rotates in
either direction, the length of the drive lever link will
need to be adjusted.
3. Adjust the linkage length by loosening the jam nuts
at both ends of the linkage and rotating the linkage
in the ball joints. Lengthen the linkage if the tire is
turning in reverse and shorten the linkage if the tire
is creeping forward. Tighten the jam nuts at both
ends. Release and re-engage the neutral lock latch
checking that the tire stops. Continue this process
until the tire no longer rotates.
Figure 7
4. Make this adjustment for both sides.
Connecting Wire Harness
1. Route the long, unattached wiring harness lead up the
left hand side of the handle and under the console.
2. Connect the two flag terminals to the OPC switch
in any order.
3. Connect the connector to the key switch.
4. Fasten the harness to the left side of handle with two
large plastic ties from the bolt bag.
5. Fasten the leads connecting to the OPC switch to
the small hole in the channel under the console using
a small tie from the bolt bag.
Servicing the Battery
WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
Important:
The machine is shipped with a filled
lead acid battery.
DANGER
Charging the battery may produce explosive gasses.
Battery gasses can explode causing serious injury.
•
Keep sparks, flames, or cigarettes away from
battery.
•
Ventilate when charging or using battery in an
enclosed space.
•
Make sure venting path of battery is always open
once battery is filled with acid.
1. Check the voltage of the battery with a digital
voltmeter. Locate the voltage reading of the battery
in the table below and charge the battery for the
recommended time interval to bring the charge up
to a full charge of 12.6 volts or greater.
Important:
Make sure the negative battery
cable is disconnected and the battery charger
used for charging the battery has an output of
16 volts and 7 amps or less to avoid damaging
the battery (see chart below for recommended
charger settings).
Voltage
Reading
Percent
Charge
Maximum
Charger
Settings
Charging
Interval
12.6 or
greater
100%
16 volts/7
amps
No Charging
Required
12.4 – 12.6
75–100%
16 volts/7
amps
30 Minutes
12.2 – 12.4
50–75%
16 volts/7
amps
1 Hour
12.0–12.2
25–50%
14.4 volts/4
amps
2 Hours
5
