Operation
9.
Torque the 3/8-16 nyloc nut.
•
For the outer anti-scalp rollers, torque to
50–55 ft-lb (68-75 N-m) (Figure 13).
g281900
Figure 13
Outer Anti-Scalp Roller
1.
3/8-16 x 3 3/4 Grade 8
bolt
3.
Front right anti-scalp
bracket shown
2.
Spring disc washer
(cone towards bolt )
4.
3/8 nyloc-torque to
50–55 ft-lb (68-75 N-m)
•
For the center anti-scalp rollers, torque to
30-35 ft-lb (41-47 N-m).
g035123
Figure 14
Center Anti-Scalp Roller
1.
3/8 inch nyloc-torque to
30-35 ft-lb (41-47 N-m)
3.
Wheel spacer
2.
Anti-scalp rollers
4.
3/8-16 x 7 3/8 inch bolt
After Operation
General Safety
•
Park machine on level ground, disengage drives,
set parking brake, stop engine, remove key or
disconnect spark plug wire. Wait for all movement
to stop and allow the machine to cool before
adjusting, cleaning, repairing, or storing. Never
allow untrained personnel to service machine.
•
Clean the machine as stated in the Maintenance
section. Keep engine and engine area free from
accumulation of grass, leaves, excessive grease
or oil, and other debris which can accumulate
in these areas. These materials can become
combustible and may result in a fire.
•
Frequently check for worn or deteriorating
components that could create a hazard. Tighten
loose hardware.
Transporting
Transporting the Machine
Use a heavy-duty trailer or truck to transport the
machine. Ensure that the trailer or truck has all
necessary lighting and marking as required by law.
Thoroughly read all of the safety instructions.
Knowing this information could help you, your
family, pets, or bystanders avoid injury.
To transport the machine:
•
Use full width ramps when loading the machine.
•
Be sure the fuel shut-off valve is closed.
•
Engage the park brake, then block the wheels. Do
Not rely solely on the parking brake to hold the
machine on the trailer.
•
Securely fasten the machine to the trailer or truck
with straps, chains, cable, or ropes. If possible,
both front and rear straps should be directed
down and outward from the machine.
•
Secure a trailer to the towing vehicle with safety
chains.
24
Содержание STARIS S Series
