Exmark SAR481KA30, Руководство оператора

Страница: 28 / 44

Maintenance
Remove spark plugs, check condition and reset gaps,
or replace with new plugs. See Engine Owner's
Manual.
Change Fuel Filter
Service Interval: As required
A fuel filter is installed in the fuel line between the
fuel tank and the engine. Replace when necessary.
Replacement Filters
Kawasaki Kawasaki
P/N 49065-7007
Note:
It is important to reinstall the fuel line hoses
and secure in place, the same way as originally
installed at the factory, to keep the fuel line away
from components.
Change Auxiliary Hydraulic
Reservoir Fluid and Filter
Service Interval: After the first 100 hours
Every 500 hours thereafter
1. Stop engine, wait for all moving parts to stop, and
remove key or spark plug wire(s). Engage parking
brake.
2. Carefully clean area around the front of the
auxiliary pump and fill cap; also clean around the
filter. It is important that no dirt or contamination
enter hydraulic system.
3. Unscrew the suction hose from the pump fitting
and allow oil to drain.
4. Unscrew the filter to remove and allow oil to
drain.
Important:
Apply a thin coat of oil on the
surface of the rubber seal.
Turn filter clockwise until rubber seal contacts the
filter adapter, then tighten the filter an additional
2/3 to 3/4 turn.
5. Reinstall the hose and torque to 37 ft-lb (50 N-m).
6. Add AW-32 hydro oil until the level reaches the
“cold fill line” located on the reservoir tank. Start
engine and raise and lower the tines. Lower the
tines to the ground and refill the reservoir to the
“cold fill line”.
Note:
Do Not change the hydraulic system oil
unless it is felt the oil has been contaminated or
been extremely hot.
Changing oil unnecessarily could damage
hydraulic system by introducing contaminates
into the system.
Change Hydraulic
Transmission Filters and
Fluid
Service Interval: After the first 100 hours
Every 500 hours thereafter
1. Stop engine, wait for all moving parts to stop, and
remove key or spark plug wire(s). Engage parking
brake.
2. Locate the two filters under the transmissions.
Remove filter guards.
3. Carefully clean area around filters. It is important
that no dirt or contamination enter hydraulic
system.
4. Unscrew filters to remove and allow oil to drain
from drive system.
Important:
Before reinstalling new filters,
apply a thin coat of Exmark Premium Hydro
Oil on the surface of the filters rubber seal.
Turn the filters clockwise until rubber seal
contacts the filter adapter then tighten the filter
an additional 3/4 to 1 full turn.
5. Remove the vent plug on each transmission and
fill through expansion reservoir, when oil comes
out of vent reinstall plug.
Exmark Premium Hydro Oil is recommended.
Refer to the chart for an acceptable alternative:
Hydro Oil Change Interval
Exmark Premium Hydro
Oil (Preferred) 500 Hours
Mobil 1 15W50 250 Hours
Torque plugs to 180 in-lb (244 N-m). Continue to
add Exmark Premium Hydro Oil until it reaches
the FULL COLD line on the expansion reservoir.
6. Raise the rear of machine up and support with
jack stands (or equivalent support) just high
enough to allow drive wheels to turn freely.
28