Exmark ARS180KA21, Руководство оператора

Страница: 24 / 36

Maintenance
Note:
Do Not remove the tank hose or o-ring
unless a replacement is needed.
12. Inspect the belt, pulleys, sprockets, and bearings;
replace as required.
13. Reinstall the expansion tank by first inserting the
hose into the tank. Place the tank opening over
the o-ring and push down to ensure a proper seal.
Install the #10–32 x 1/2 inch self tapping screw
and torque to 25 in-lb (2.8 N-m).
14. Fill the transmission, at the oil fill port, until the
oil level is 1/2–1 1/4 inches (13–32 mm) below
the top of the fill port.
Exmark Premium Hydro Oil is recommended.
Mobil 1 15W50 is an acceptable alternative.
15. Reinstall the oil fill port fitting.
16. Reinstall the transmission.
A. With the transmission belt on the engine
pulley and the idler pulley, loosely install the
transmission using its mounting hardware
(seven locations–see Figure 11) that was
removed in step 7E.
B. Install the transmission belt on the
transmission pulley.
C. Install the drive chains onto the idler and
transmission sprockets.
D. Install the chain on the front axle sprocket;
making sure the front axle sprocket is aligned
with sprocket on the transmission.
E. Tighten the transmission mounting bolts
(seven locations).
F. Tension the transmission belt as stated in
Adjusting the Transmission Drive Belt
Tension
in the Adjustments section.
G. Tension the tine drive chains as stated in the
Adjusting the Tine Drive Chain in the
Adjustments section.
H. Reconnect the self-propel drive bail cable.
17. Carefully remove the jackstands, lower the
machine to the ground, and remove the overhead
hoist hooks.
18. Raise and lock the handle into the operating
position.
19. Check the gap between the handle and the bail. If
the handle contacts the bail or if there is more
than a 1/8 inch (3mm) gap, then adjust the cable
as stated in
Adjusting the Self-Propel Drive in
the Adjustments section.
Check Spark Arrester
(if equipped)
Service Interval: Every 50 hours
WARNING
Hot exhaust system components may ignite
gasoline vapors even after the engine is stopped.
Hot particles exhausted during engine operation
may ignite flammable materials. Fire may result
in personal injury or property damage.
Do Not refuel or run engine unless spark arrester
is installed.
1. Stop engine, wait for all moving parts to stop.
2. Disconnect the wire from the spark plug.
3. Wait for muffler to cool.
4. If any breaks in the screen or welds are observed,
replace arrester.
5. If plugging of the screen is observed, remove
arrester and shake loose particles out of the
arrester and clean screen with a wire brush (soak
in solvent if necessary). Reinstall arrester on
exhaust outlet.
24