1. Trace and cut an 8 1/8” x 10 3/4” rectangular hole in the ceiling.
2. Knockout the appropriate mounting holes and wire pass-through hole.
3. Insert back box inside rectangular cutout and secure in place using cables/chains and the appropriate hardware
for the application. (supplied by others) (Fig.1).
4. All electrical connections should be made inside the junction box (supplied by others).
CAUTION!
Failure to cap unused wires may result in a shock hazard or unsafe condition as well as equipment
failure.
RMW Series
INSTALLATION INSTRUCTIONS
800.533.3948 • www.barronltg.com
10070210 Rev 2 - 04/19
1
120VAC
White - Common
Black - 120V
Green - Ground
277VAC
White - Common
Orange - 277V
Green - Ground
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
When using electrical equipment, basic safety precautions should always be followed including the following:
•
DISCONNECT AC POWER SUPPLY BEFORE SERVICING.
• Installation and servicing of this equipment should be performed by qualified service personnel only.
• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations if applicable.
• Do not mount near gas or electrical heaters.
• Do not use outdoors.
• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering by
unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Any modification or use of non-original components will void the warranty and product liability.
• Do not use this equipment for other than intended use.
• Allow battery to charge for 24 hours before first use.
SAVE THESE INSTRUCTIONS!
Fig. 1
Cable / Chains
Cable/Chains