Exhausto VEX200 series, Инструкция по механической установке

Страница: 20 / 32

5. Maintenance
5.1 Maintenance chart
Recommended in-
tervals The following chart details the recommended maintenance intervals, under normal
operating conditions. EXHAUSTO recommends maintenance is adjusted to suit
the actual operating requirements.
Component Procedure Once a
year
Twice a
year
Filters* Recommended that both filters are replaced at the
same time.
Filters should be replaced at least: X
Filter monitor Check that all the seals in the filter monitor are
tight. X
Seals and sealing strips Check that all the seals are tight. X
Fans and heating coil (ac-
cessories) Check
Removal of fan unit. See section "Internal trans-
port with reduced weight"
Cleaning. See next section X
Rotary heat exchanger Check
Clean when required. See next section. X
*Filters Only use original filters
● The provided filter data and pressure loss graphs (section "Technical data")
are based on the use of original filters
● EUROVENT certification is only valid if original filters are used
● Use of non-original filters may cause leakage in the VEX and impair filter
function
● EXHAUSTO recommends that you register the filter replacement date to en-
sure filters are replaced at the correct intervals
5.2 Service
5.2.1 Filter change
Use original filters Only use original filters. See section "Maintenance chart".
Disconnect power at the isolation switch before opening the
door.
Pull the filters out. Remember to check the flow direction - see the arrows on the
filter.
Discarded filters must be stored immediately in sealed plastic bags and disposed
of responsibly.
3005039-2018-01-08
Maintenance
20/32