8 080105A-1
3.
Insert the Ni-Cd battery into the battery compartment.
4.
Replace the battery compartment cover by sliding it up towards the handset.
NOTE:
Use the type and size of Ni-Cd battery pack, 3.6V, 450mAh. It is recommended that the Ni-Cd
battery pack should be fully charged overnight prior to initial use.
Belt Clip Installation
With the back of handset facing up, insert one side of the belt clip hook into the matching slots at the top
side of handset as shown in Figure2. Slide the other hook until it locks into place from the opposite side
of the handset.
WALL USE:
Wall Mounting (Standard Wall Jack)
1.
Install the wall mount bracket at the position as shown in Figure 3.
2.
Connect the short telephone line cord to the TEL LINE jack..
3.
Connect the opposite end of the telephone line cord to the modular wall jack.
4.
Align the wall mounting slots with studs located on the modular wall plate and slide base down to
lock in place.
Wall Mounting (No Standard Wall Jack)
1.
Drill two holes with a vertical distance between the two marked positions of 3
15/16
"
(
100mm
)
as
shown in Figure 4.
2.
Drive a screw into each of the holes. Tighten them to the end of the screw lines, only leaving the
Belt clip hook
Wall Mount Bracket
Wall Mount
Stud
Telephone
Modular
Jack
Wall Mount
Stud
(Figure 3)
(Figure 2)
(Figure 4)
Содержание 36007
Страница 1: ......
