Excera EP3120 U1, Руководство пользователя

Страница: 6 / 19

4 3
BATTERY INFORMATION
Charging Operation
The battery pack is not charged at the factory; please charge it before use.
Charging the battery pack for the first time or after extended storage (more than 2 moths) may not
bring the battery pack to its normal operating capacity. The peak operating capacity of the battery
will be reached after two or three charge/discharge cycles. The battery pack life is over when its
operating time decreases even though it is fully and correctly charged and should be replaced.
Charger Applied
Please use the specific charger provided by our company. Other chargers may cause explosion and
personal injury. After installing the battery pack, if the radio displays low battery with red flashing
lamp or voice prompt, please charge the battery.
Notice for Charging Battery
▼ Do not short circuit the battery terminals or throw the battery into fire. Never attempt to remove the
casing from the battery pack, we show no responsibility for any results caused by modifying freely
without permission of our factory.
▼ The ambient temperature should be between 5
℃
and 40
℃
while charging is in progress. Charging
outside this range may not fully charge the battery.
▼ Always switch OFF the transceiver before charging, otherwise it will interfere with correct charging.
▼ To ensure correct charging, do not cut off the power or take out the battery during charging.
▼ Do not recharge the battery pack if it is already fully charged. This may shorten the life of the
battery pack or damage the battery pack.
▼ Do not charge the battery or transceiver if it is damp. Dry it before charging to avoid danger.
BATTERY INFORMATION
WARNING: If the battery terminals short circuit, it will generate a lot of heat and possibly a fire.
When using or storing the radio (or just the battery), keep keys and other metal objects away from
the battery terminal contacts.
How to Charge
1. Plug the AC adapter into the AC outlet, and then plug
the cable of the AC adapter into the DC jack located
on the back of the charger. The indicator lights orange
(1s) and then goes out indicating it is ready to charge.
2. Plug the battery or transceiver equipped with battery
into the charger. Make sure that the battery terminals
in contact with the charging terminals well. The
indicator light turns to twinkling red, meaning pre-
charging begins.
3. After pre-charging for about 5 minutes, the indicator
light will stop twinkling, meaning charging begins.
4. It takes approximately 4 hours to fully charge the battery. When the lamp lights green, the
charging is finished. Remove the battery or the transceiver equipped with battery from socket.