excelPTZ PTZ200, Инструкция по установке и эксплуатации

Страница: 5 / 31

5
Getting the dome up and running!
You MUST connect up the dome and your control equipment on a workbench or kitchen table before the
actual site installation and CHECK YOU KNOW HOW TO INSTALL IT CORRECTLY!!!!!!!!!!!!!!!!!.
By doing this you can set-up any DIP switches, adjust the camera, and learn about how it operates before
taking it to site. This will save you hours of time on-site trying to work out why a particular item doesn’ t
function as you expected it to. There is nothing worse than installing something and then having to take it
down to see how to get it working!! Do the learning curve in the comfort of your own premises!!!!
Overview-
introduction to fitting PTZ equipment
Generally speaking, PTZ Domes requires four things;
1- They require a power supply and a cable to supply this power to the dome. Often, external
domes are 24V A.C but some mini pan and tilt domes such as this model, are 12V.
2- They require a cable to get the video signal back to the monitor or recording device.
3- They require a cable to transmit the “RS485 control signal” from the keypad or DVR to tell the
dome to pan and tilt etc.
4- They require something to control them, either a keypad or a DVR.
The following diagram indicates the basic cable requirements for a PTZ system.
Do you KNOW how to install PTZ equipment that is
controlled by RS485 data signals?
If not please read the following introduction to PTZ >>>… .