excelPTZ PTZ200, Инструкция по установке и эксплуатации

Страница: 22 / 31

22
PRESETS and other functions.
The dome has up to 32 presets that once programmed with stay in the domes non-volatile memory so they
will be retained even after a power cut.
What is a preset? A preset is a particular area or object that the dome was looking at and has been stored into
its memory so when the preset is “called-up” the dome will select the area again without the operator using
the joystick to do this. This means that you could for example store a PRESET of a car-park entrance. When
the operator calls up this preset the dome automatically moves to this location. By storing more than one
preset you can add even more functionality to the dome. By having two presets, you can then get the dome to
“SCAN” between the two locations.
Having 3 or more presets you can get the dome to go on a TOUR (PATROL) of the presets. When you run
the patrol the dome goes to one preset, then waits a short period then on to the next preset and so on. The
dome continues to cycle around this patrol until you cancel it. The length of time the camera stays at each
location is set in this dome at 4 seconds and the speed of travel between each preset point is 7.5
°
per second.
In the dome some preset numbers are reserved for special functions, these are listed as follows;
What you press at the keyboard
PRESET
No.
Special function
Press XX then CALL
(XX = preset No)
Press XX then PRESET
(XX= preset No)
51 Starts an Auto Scan Starts a TOUR
52 -
The location the Auto Scan
starts from.
53 -
The location the Auto Scan
ends at
If you wish to use the Auto Scan function YOU MUST FIRST USE preset 52 as the starting point of the scan
and preset 53 as the ending point of the scan.
PRESETS -How to set up a preset
Aim the dome where you want it to look and zoom in or out to get the correct scene. Now press the
following keys on the keypad : xx PRESET (where xx is the preset number you wish to store). For example
01 PRESET would store PRESET 01 and the camera would always go to this location when 01 is
“CALLED”. Ensure that you do not keep the preset button depressed, as this will delete the preset.
To test if the preset is stored correctly use the joystick to move the camera to a point in a new location. Now
press xx CALL (where xx is the preset you wish the camera to go to). In this example if you press 01 CALL
the dome should go straight to the PRESET 01 location.
TIP -You may wish to write down a list of presets that you have stored next to the keypad for the operator.
Auto Scan / Tour
Auto Scan
Auto Scan