Copyright © 2017 MAT Industries, LLC
11 - ENG
OPERATING INSTRUCTIONS
• SAVE ALL INSTRUCTIONS
START-UP PROCEDURE
1. Ensure water supply is connected and
turned on.
2. Release gun safety lock.
3. To allow air to escape from the hose, squeeze
trigger on the gun until there is a steady
stream of water coming from the nozzle.
4. Remove any dirt or foreign matter from the
gun outlet and the male connector of the wand.
5. Insert the nozzle wand into the gun wand
and tighten the twistfast fitting securely by
hand.
STARTING THE ENGINE
(See Figure 1, page 10)
1. Check oil and fuel level.
2. Adjust choke as necessary.
3. Set the engine switch to the “ON” position.
4. Squeeze trigger on pressure washer to
release pressure while pulling on the
engine starter rope with a fast steady pull.
Pressure may otherwise build up making
starting the unit difficult.
5. As the engine warms up, open the choke
to full.
WARNING
If the wand or nozzle is
not securely locked into place, it could
be ejected under high pressure when
operating the gun, possibly causing injury
or damage.
CHEMICAL INJECTION
• SAVE ALL INSTRUCTIONS
1. Ensure that one end of the chemical
injection tube is attached to the siphon
injector on the pump (see Figure 1, page 10)
2. Ensure that the other end of the chemical
injection tube is attached to the nipple on
the bottom of the chemical tank
3. Fill your chemical tank with your cleaner of
choice (most cleaners are concentrated,
please follow the mixing instructions as
outlined by the manufacturer of the cleaner).
4. Install the black quick connect, low
pressure nozzle on the spray wand. The
solution will automatically be mixed with
the water and discharged through the nozzle.
NOTICE
This pressure washer is
intended for use only with liquid car wash
detergents, developed specifically for
pressure washer and with mild soaps.
Only use chemicals compatible with the
aluminum and brass parts of the pressure
washer. Powdered soaps may clog the
injection system. Always use chemicals
according to manufacturer directions. MAT
Industries, LLC assumes no responsibility
for any damages caused by chemicals
injected through this pressure washer.
