E X C E L D R Y E R , I n c .
P h o n e 1 . 8 0 0 . 2 5 5 . 9 2 3 5
s a l e s @ e x c e l d r y e r. c o m
E a s t L o n g m e a d o w, M A
F a x
1 . 4 1 3 . 5 2 5 . 2 8 5 3
w w w. e x c e l d r y e r. c o m
P A G E 6
INSTALLATION INSTRUCTIONS
for dryer with 40103
(CONTINUED)
Step 3-5.
With the retainer removed, pull the corner of the dryer
out away from the base plate enough to pull the green ground wire
underneath the dryer foot toward the bottom of the dryer. (
Figure 3-5
)
Figure 3-5
40525
Step 3-6.
Reinstall the
two (2)
screws and plastic housing retainer
onto the foot of the dryer. Make sure that the ribs on the housing
retainer is facing outward or facing away from the dryer. (
Figure 3-6
)
Figure 3-6
Step 3-7.
Arrange control (Previously removed in step 3-2)
and the HEPA Filter Adapter (A) as shown (
Figure 3-7
)
Figure 3-7
Step 3-8.
Set HEPA Filter Adapter (A) on top of Control and align the three
mounting holes in the Adapter to three matching holes on the control bracket.
Use the
three (3)
#6-32 self tapping screws (D) to attach the Control to the
HEPA Filter Adapter. (
Figure 3-8
)
Figure 3-8
Ribs facing
outward
Dryer foot
Green wire
under foot
Control
HEPA Filter Adapter
HEPA Filter Adapter
Control
Screws
Step 3-9.
Attach Control Harness Connector to Control and route wires making
sure wires are installed under white Wire clip on the adapter (
Figure 3-9
).
Reconnect green ground wire back on quick connect tab on bracket. Reconnect
sensor to Control. (
Figure 3-2
)
Figure 3-9
Wire routing
Wire clip
