Step by Step Installation Guide
Use the appropriate template for your installation and place
the template on the door and frame. Pilot drill all fixing holes
as per the template.
1.
Position the door closer with the adjustment valves facing
away from the hinge side of the door. Secure the door closer
and bracket using the screws provided into the pre-drilled
pilot positioning holes.
2.
Remove the shoe from the door closer arm.
3.
Attach the armset to the pivot on the door closer body parallel
to the door/frame and secure using the washer screw.
4.
Tension the door closer arm and adjust the arm length
accordingly. Secure the arm to the figure 66 bracket and tighten
the arm set nut.
5.
Add the dust cap to the unused pivot.
6.
Adjust the closing and latching speeds as required -
refer to adjustment instructions.
NB after the first month of operation the closing and latching
speed valves may require minor adjustment.
XL8500 Series
Door Closer Installation
Right hand fitting only, use reverse for left hand fitting.
4 8
4
1
1
1
EN1154:1996 / A1:2002 / AC:2006
EN1634-1:2008 FD30/FD60 Timber Doors
*Fig 1 Application Only
30/60
b
3
2
3
1
4
5
6
7
8
9
Parallel Arm Installation
(Push Side) - Fig 66
Key
1.
Armset
2.
Nuts
3.
Adjustment Valves
4.
Threaded Arm (Bolt)
5.
Threaded Arm (Bolt)
6.
Parallel Bracket (Figure 66)
7.
Door Closer Body
8.
Dust Cap
9.
Washer Screw
10.
Assembling Screw
10
2 - Latching
Speed
1 - Closing
Speed
CAUTION
Adjusting valves more than 2 full turns
anti-clockwise from factory settings will
result in oil leakage damaging the door closer.
Failure to comply with this will void the warranty.
Acceleration
Deceleration
Valve Adujustment Instruction Guide
Closing Speed:
Adjust valve by quarter turns
anti-clockwise to increase speed or clockwise to
reduce speed.
Latching Speed:
Adjust valve by quarter turns
anti-clockwise to increase speed or clockwise to
reduce speed.
is
not
visible
