Excalibur RS-350-EDP, Руководство по эксплуатации

Страница: 8 / 16

8
Valet Mode
Valet mode prevents the remote start feature from being activated. It also dis-
ables horn honks when locking or unlocking the doors. Valet Mode should be used
when you do not wish for remote starting to be operated, such as when you have
your vehicle serviced. To engage Valet Mode:
• With the system “unlocked”, press and hold the Valet Switch for 3 seconds; the
optional Status Light will turn on and stay on to indicate Valet Mode. The horn will
honk once and the lights will flash twice. Once in Valet Mode, an attempt to remote
start will result in no response. Keep this in mind if remote start stops functioning.
while the system is in Valet Mode, the horn will honk once every time the ignition
key is turned OFF.
• To turn off Valet Mode, simply press & release the Valet Switch once. The Status
Light will turn off.
Emergency Override
If the system is locked, you cannot perform functions like transmitter or feature
programming. If you do not have a transmitter to unlock the system, you can perform
an emergency override to access the programming functions.
• With the system in a locked state, simply turn the ignition key to the RUN/ON
position and press and release the valet switch once.
Using The Valet Switch
Other Remote Start Features (cont’d)
The Status Light (Optional)
The optional Status Light helps to visually confirms the status of the system and
provides a high level of visual deterrence. The Status Light is typically installed
somewhere on the dash. Consult with your installer if there are any questions.
Normal System Status
1) Off = The remote starter system is off, in standby mode.
2) On Constant = The system is in the Valet Mode, with the remote starter system
disabled.
Starting System Status
The Status Light also indicates the remote start status:
3) Flashing Very Slow (once every 2 seconds): The system is in manual transmis-
sion remote start mode and awaiting a remote start command.
4) Flashing Slow (once per second): Remote start is on.
4) Press LOCK on the transmitter. The engine will shut down (unless turbo timer is
on) and the status light will flash every 2 seconds to indicate it is ready to be remote
started.
NOTE: Manual transmission starting is canceled if you enter the vehicle after per-
forming the setup procedure. After remote starting, you have 20 seconds to turn on
the ignition key AFTER opening a door.