Page - 13
Passive System Arming And Rearming
Automatic Last Door Arming: Your security system can be programmed to arm automati-
cally when the vehicle's last door is closed. The moment the last door closes the siren will chirp
once (or the horn will honk once), the parking lights and dome lights will flash once and the
LED Status Indicator will begin to flash rapidly. Thirty seconds later the siren will again chirp
once (or the horn will honk again), the lights will flash once, the doors will lock (if the Last Door
Lock feature has also been chosen) and the LED Status Indicator will slow to a steady flash,
confirming that the security system is fully armed. However, if a point of entry is reopened
before the single siren chirp (or horn honk) and light flash at 30 seconds, this passive arming
process stops, and will reset to start over again when that point of entry is reclosed.
"Automatic Last Door Arming" offers a high level of security, since it does not require you
to remember to arm the security system when you leave your vehicle. Additionally, Automatic
Last Door Arming may entitle you to an insurance discount. Please note that the previously
described Arming Bypass feature does not operate with Automatic Last Door Arming. The
Arming Bypass is designed to operate only when arming from the transmitter, because all
protected entries must be closed prior to the Automatic Last Door Arming sequence to start.
To prevent the system from automatically arming while the vehicle is being refueled you
should put the system in Valet Mode, or keep your door open. We do not recommend leaving
Page - 14
your ignition key turned "on". Last Door Arming does not effect the operation or use of the
transmitter to arm the system - if desired, the transmitter may still be used to arm the system
at any time.
Automatic Rearming:
Selecting this feature adds Automatic Rearming, which is
independent of Automatic Last Door Arming. This feature will cause the system to
automatically rearm itself 90 seconds after disarming, unless the ignition switch is turned "on".
This prevents the accidental disarming of the system by the inadvertent pressing of the
transmitter's button while placing it in a purse or pocket. If the "Automatic Relocking"
Programmable Feature is utilized, the doors will also lock when the system automatically
rearms. Automatic Rearming is indicated by a fast flashing LED Status Light during the 90
seconds, then a parking and dome light flash when the system rearms.
Remote Valet: This Feature, which operates as part of the Automatic Rearming Feature,
will temporarily cancel the Automatic Rearming. To use Remote Valet, press and release the
small lower transmitter button within 3 seconds after pressing the large transmitter button
when disarming the system. The parking lights will flash on and off, and the LED Status
Indicator will illuminate steady to confirm Remote Valet operation. The system will remain in
Remote Valet mode until armed again by transmitter; or, the Valet Switch may be pressed.
Page - 15
While the security system is armed, the LED Status Indicator will be flashing. Should any
intrusion attempt occur, your system will instantly activate, or "trigger". Once triggered, the
system will:
1)
Sound the electronic siren or the vehicle's horn. The siren features six different tones,
and every 5 seconds the siren will change the tone to generate more attention to the
vehicle. The horn will sound a series of honks, sounding for one second, then pausing
one second. Every ten seconds, the horn honking will pause completely for 5
seconds, which avoids overheating the horn. This will occur for the duration of the
activated cycle.
2)
The exterior lights will flash.
3)
The doors will relock. This feature is so unique that the security system monitors the
status of the door and, if open, the system waits until the door is closed, at which time
it relocks the doors, so that the thief cannot easily regain entry.
The siren (or horn) and the parking lights will stay active for 60 seconds, or, unless you
disarm the system with the transmitter or by using the Valet Override. If all protected entries
are secure at the end of 60 seconds, the system will stop and rearm automatically to detect
another entry attempt. If there is a protected entry still open, or an optional sensor still in a
triggered state at the end of 60 seconds, the system will reactivate for two more 60 second
Security System Armed And Activated
Page - 16
cycles. The system will stop after a total of 3 minutes and rearm automatically, while ignoring
only the open entry or triggered circuit. When the entry is closed, protection will begin
instantly for that circuit.
After the activation of the security system, the disarm confirmation will no longer be 2 siren
chirps (or horn honks), and the parking lights staying on. Instead, the system responds by
producing 4 siren chirps (or horn honks) and the parking lights and dome lights flash 4 times
before staying on for 30 seconds. The LED Status Light changes to flashing two to five times,
then pausing 1 second to indicate which protected zone triggered the system. The LED Status
Light will continue flashing this Zone Violation Code until the ignition switch is turned “on”,
which clears the system's LED Status Light memory circuit.
Disarming The System Using The Transmitter
While the security system is in the armed state, pressing and releasing the large transmitter
button once will instantly disarm the system and unlock the doors. Disarming is confirmed
by the siren chirping twice (or the horn honking twice), and the parking and interior lights
turning on for 30 seconds. However, the lights will turn off instantly if the ignition switch is
turned "on". If the system was triggered while you are away, the disarm confirmation will
change to four siren chirps (or 4 horn honks), 4 light flashes, and then the lights will stay on
for 30 seconds, to illuminate the way to your vehicle. The security system will have this
response upon disarming until the ignition switch is turned "on", which clears the unit's
memory. Anytime the security system triggers, the LED Status Light will
