90-DAY LIMITED WARRANTY
EXCALIBUR ELECTRONICS, INC., warrants to the original consumer that its products are free from any electrical or mechanical defects for a period
of 90 DAYS from the date of purchase. If any such defect is discovered within the warranty period, EXCALIBUR ELECTRONICS, INC., will repair or
replace the unit free of charge upon receipt of the unit, shipped postage prepaid and insured to the factory address below.
The warranty covers normal consumer use and does not cover damage that occurs in shipment or failure that results from alterations, accident, misuse,
abuse, neglect, wear and tear, inadequate maintenance, commercial use, or unreasonable use of the unit. This warranty does not cover cost of repairs made
or attempted outside of the factory.
Any applicable implied warranties, including warranties of merchantability and fi tness, are hereby limited to 90 DAYS from the date of purchase. Con-
sequential or incidental damages resulting from a breach of any applicable express or implied warranties are hereby excluded. Some states do not allow
limitations on the duration of LIMITED 90-DAY WARRANTY implied warranties and do not allow exclusion of incidental or consequential damages, so
the above limitations and exclusions in these instances may not apply. The only authorized service center in the United States is:
Excalibur Electronics, Inc.
13755 SW 119th Ave
Miami, Florida 33186 U.S.A.
Phone: 305.477.8080
Fax: 305.477.9516
www.ExcaliburElectronics.com
Ship the unit carefully packed, preferably in the original carton, and send it prepaid, and adequately insured. Include a letter, detailing the complaint and
including your daytime telephone number, inside the shipping carton. If your warranty has expired and you want an estimated fee for service, write to the
above address, specifying the model and the problem.
N
OTE
: Please do not send your unit without fi rst receiving an estimate for servicing from EXCALIBUR ELECTRONICS, INC. Contact us before sending
your unit. We cannot store your unit!
Excalibur Electronics, Inc. reserves the right to make technical changes without notice in the interest of progress.
C
ARE
& H
ANDLING
• Do not submerge remote control in water or other liquids.
• Do not disassemble the product for any reason.
• Do not expose to extreme temperatures.
• Do not drop, throw, smash or otherwise cause physical shock.
• Clean using only a slightly damp cloth.
• Do not use cleaners with chemical agents.
B
ATTERY
I
NFORMATION
• Do not short-circuit the battery terminals.
• Do not use rechargeable batteries.
• Do not mix old and new batteries.
• Remove exhausted batteries.
• Batteries should be installed and replaced by an adult only.
• Remove batteries when not in use.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-
cadmium) batteries.
AmphibiCar
Model No.:
PR36
012709
Please Visit Us @ www.ExcaliburElectronics.com
This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions: (1) this device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the fol-
lowing measures.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.