Excalibur AL-1950-EDPB, Руководство по эксплуатации

Страница: 20 / 28

20
user Programmable Features
To custom program a new SecureCode:
Step 1 Follow Steps 1 to 4 in the previous “Programming Features” section to access
“feature #1”�
Step 2 Within 10 seconds slowly press and release the controller or transmitter’s
“ arm/lock ” button the number of times equal to the desired SecureCode for stage 1,
allow the system to respond to each controller/transmitter button press with a siren
chirp before pressing the button again. A few seconds after the final button press, the
system will chirp the horn/siren confirming the total number for stage 1.
Step 3 Configure stage 2 of the SecureCode by pressing and releasing the “ disarm/
unlock ” button the number of times desired for the stage 2. The system will confirm
as it did for stage 1�
Feature #2 - Last Door Arming
Off (press “ lock ” button to program) - DEFAuLT
On w/o Doors Locking (press “ unlock ” button to program)
On w/ Doors Locking (press “ trunk ” button to program)
“Last Door Arming” has the system automatically arm itself every time you exit the
vehicle (the complete operation is described on page 10)� This feature turns that op-
eration on or off, and with options of having Last Door Arming operate with or without
also locking the doors when the system does arm�
Feature #1 - SecureCode
DEFAuLT - 1 Press
SecureCode is a unique patented feature which allows you to custom select the num-
ber of Valet Switch presses in two stages, instead of a single “1 press”, which would
be required in order to perform an Emergency Override� If any of the three anti-car-
jacking features are utilized, a customized SecureCode would also be required to turn
it off once it is fully activated� The SecureCode operation is described on page 12�
Feature #3 - Automatic Rearming
Off (press “ lock ” button to program) - DEFAuLT
On w/o Doors Locking (press “ unlock ” button to program)
On w/ Doors Locking (press “ trunk ” button to program)
Enhanced Auto Rearm (press “ start ” button to program)
“Automatic Rearming”, described on page 10, rearms the alarm if accidentally dis-
armed� Options are to have Automatic Rearming operate with or without also locking
the doors when the system does rearm� Enhanced auto rearm allows you to cancel
the rearming sequence by pressing unlock a 2nd time after disarming�
Feature #4 - Starter Interrupt Functions
Alarm Only (press “ lock ” button to program) - DEFAuLT
Anti-Grind Only (press “ unlock ” button to program)
Alarm & Anti-Grind (press “ trunk ” button to program)
Automatic (press “ start ” button to program)
Alarm Only - The Starter Interrupt is operable whenever the alarm is armed�
Anti-Grind Only - The Starter Interrupt is operable whenever remote start is on�
Alarm & Anti-Grind - This setting engages starter interrupt when the alarm is armed
AND when the system is in remote start mode� This prevents the starter from grinding
if the user accidentally turns the key to “START” during remote start�
Automatic - This will cause the Starter Interrupt output to automatically engage 90
seconds after the ignition switch is turned “off”, and after disarming�