Exalt Installation and Management Guide
ExtendAir (TDD) Series
203591-004
33
2010-09-20
Configuration and Management
This section describes the command line interface (CLI) and Exalt graphical user interface (GUI).
Telnet into the Command Line Interface (CLI)
Use a Telnet connection to access the CLI in the Exalt Digital Microwave Radios. Use the CLI to set
key parameters on the system.
Connect to the Radio in a Telnet Session
Make the Telnet connection to the radio through the Ethernet port. Use Windows and perform the
following steps:
1
Open a command prompt or MS-DOS prompt (
Start>Run
).
2
Type C:\>Telnet <IP Address> at the command line:
The default IP address is
10.0.0.1
Telnet
Use Telnet when prompted to enter the administration level login and password. The default
administration login is
admin
and password is
password
. It is recommended that the default
administration password be reset by performing a radio reset (see
Reset to Critical Factory Settings
Figure 13 shows the three menu choices available after log in.
Figure 13 CLI main menu
The following selections can be made on all screens:
•
0 = back to previous screen
Note:
The accessing computer must be on the same IP subnet as the radio. If the radio has
DHCP enabled on the PoE port (see
Ethernet Interface Configuration Page
default setting for a radio shipped from Exalt, and your computer's Ethernet port is set for
DHCP addressing, the radio will configure your computer to 10.0.0.2, and no manual IP
configuration is required for your computer.
