XD2500 User Guide
© 2009 ExaDigm, Inc.
Page 6 of 10
Rev. 5/0609
5.0
Installing a Paper Roll
A paper roll is required to print receipts and reports. Follow the steps below to install a paper roll:
1. Place forefinger under flap at top of printer compartment and pull forward using force.
2. Using tab lift compartment up.
3. Place the paper roll in the printer compartment.
4. Close the printer compartment door by pressing until it clicks into place.
6.0
Installing and Removing the Battery Pack
The power pack allows the terminal to operate when not connected to a power outlet. Follow the steps
below to install the terminal’s battery pack.
1. Remove the battery door by placing your finger on the tab and pushing down. While pushing
down pull toward you and slide the door up to remove.
2. Remove the battery by placing a finger on the tab and pulling up. The battery will loosen and slide
to the right, clearing the locking tabs pull the battery out.
3. To install slide the battery under the locking tabs on the left and push down.
4. Replace the battery door by inserting the bottom hedge in first, push down until it snaps into place.
7.0
SIM Chip Installation
Note:
SIM chips are only used in GSM modems.
1. The SIM chip slot is located with the terminal face down under the battery compartment. The
battery door must be removed by placing your finger on the tab and pushing down. While pushing
down pull toward you and slide the door up to remove.
2. Remove the battery by placing a finger on the tab and pulling up. The battery will loosen and slide
to the right, clearing the locking tabs pull the battery out.
3. There are two compartments be sure to use the one located on the right. The SIM chip will be
protected by a locking gate.
4. To open the gate, carefully use your fingernail or a small flathead screwdriver to slide the gate
from the LOCKED to the UNLOCKED position (slide down to unlock). The distance required is
about 1/8 inches or 3mm.
5. Once unlocked, use the square slot to open the gate. The gate is on a hinge and should NOT be
removed from the modem.
