NX1200 User Guide
© 2014 ExaDigm, Inc.
Page 7 of 16
Rev. 1/0614
7.0
Powering Terminal
8.0
Card Readers
9.0
NFC/Contactless
10.0
Modem Configurations
Ensure that the terminal is properly connected to an active power source.
Dial
Connect the phone cord to the LINE port on the back of the terminal.
GSM/GPRS
Before you use the terminal to do live transactions with TCP/IP connections, you need to make sure the
modem is activated by inserting the SIM card. Contact your network carrier, ISO or ExaDigm to confirm
activation.
Ethernet
Connect the Ethernet cable to the Ethernet port (LAN) on the back of the terminal.
WiFi
Connect the mini USB stick to the USB port on the side of the NX1200.
Insert Smart Card into smart card reader slot
located on the bottom front side of the
terminal.
To power on terminal press red Power key
until beep is heard. The boot up process will
display.
To power down terminal tap the red Power
key briefly, the message shown will appear.
Press [ENTER] to complete process.
Power OFF
[ENTER] Power OFF
[ENTER] or [CANCEL]
Swipe card through reader with the magnetic
stripe facing down and toward the terminal.
Tap
the
NFC
card
over
the
paper
compartment.
