eXact PipeCut P1000, Руководство по эксплуатации

Страница: 7 / 19

Safety English
6
Definitions: Safety instructions
The definitions below describe the level of severity for
each signal word. Please read the manual and pay
attention to these symbols
DANGER : Indicates an imminently hazardous
situation which, if not avoided, will result in serious
injury or in extreme cases a fatality
WARNING : Indicates a potentially hazardous
situation which, if not avoided, could result in serious
injury or in extreme cases a fatality
CAUTION:
Indicates a potentially hazardous
situation which, if not avoided, may result in minor or
moderate injury.
NOTICE: Indicates a practice not related to
personal injury which, if not avoided, may result
in property damage.
Denotes risk of electric shock.
Symbols found on the machine.
Use ear protection.
Use gloves.
Read instructions before use
.
Laser radiation: Do not look directly into beam.
Saw blade: Saw blade behind this cover, do not insert
fingers or other body parts inside this cover.
Operating, safety and service
instructions
Read these operating, safety and service
instructions carefully before operating the pipe saw.
Store these instructions in a place where all pipe
saw operators have access. In addition to these
instructions official work, health and safety rules
must be followed. Exact PipeCut is for professional
use only.
Please notice the article number on the type plate of
your machine. The trade names of the individual
machines may vary.
Only for power tools without reduced starting current:
Starting cycles generate brief voltage drops.
Interference with other equipment/machines may occur
in case of unfavorable mains system conditions.
Malfunctions are not to be expected for system
impedances below 0.36 ohm.
Noise/vibration Information
The vibration emission level given in this information
sheet has been measured in accordance with a
standardized test given in EN62481-2-5:2014
Use ear protection!
Vibration level values
(sum of vectors of three
directions) are defined in accordance with standard
EN62841-2-5:2014:
Vibration rate a
h
< 2,5 m/s ²,
Uncertainty K = 1,5 m/s².
The vibration emission level given in this information
sheet has been measured in accordance with a
standardized test given in EN62841-2-5:2014 and may
be used to compare one tool with another. It may be
used for a preliminary assessment of exposure.
WARNING : The declared vibration emission
level represents the level during main applications of
the tool.
However, if the tool is used for different applications,
with different accessories or poorly maintained, the
vibration emission may differ. This may significantly
increase the exposure level over the total working
period.
An estimation of the level of exposure to vibration
should also take into account the times when the tool is
switched off or when it is running but not actually doing
the job. This may significantly reduce the exposure
level over the total working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as: maintain
the tool and the accessories, keep the hands warm,
organize work patterns.
WARNING:
If Pipecut Exact PipeCut P1000 tool is used with
generator or extension cords, their minimum
requirements are as follows:
Generator: minimum power of 3500 watts, if other
electrical equipment is not used at the same time.
Extension cords 230 V: The maximum length - 25
meters. Cable cross section - not less than 1,5mm ².
Extension cords 120 V: The maximum length – 82 Feet
Extra Heavy Duty