Manual FRAME-PF-UNI-PORAD
Version 1.2
03.04.2020
Page 12 of 19
Step 2: One can choose between those two sets of screws. Use the 5 mm hex key
to tighten the four M6 screws with a torque of 10±0.5 Nm and the 6 mm hex key
to tighten the four M8 screws with a torque of 25±0.5 Nm. All four M6 screws or
all four M8 screws have to be used.
Step 3: With the help of the Nr 13. screw wrench, tighten the four M8 DIN 439
nuts. If the M6 screws are chosen, please use the Nr 10. screw wrench for tighten
the four M6 DIN 439 nuts.
6.
Adjusting the rigging clamp position
Always do this procedure before attaching the Portrait Adapter to the
frame. Otherwise accidents can occur!
Step 1: Untighten the four M10 DIN 980 safety nuts until there is a gap of max.1
mm between the nut and the 10 mm safety washer.
Do not remove the M10 DIN 980 safety nuts completely because accidents
can occur!
m
ax.
1 mm
ga
p
Torque: 50 Nm
