8- ENG
A11756
HOW TO USE SPRAY WAND
Your pressure washer is equipped
with a multi-adjustable spray wand
with both high and low pressure
settings. The high pressure setting
is for cleaning and rinsing, the low
pressure setting is for applying
chemicals or cleaning solutions to
surfaces.
When using the
high pressure
setting, DO NOT allow the jet-like
spray to come in contact with
unprotected skin, eyes, or with any
pets or animals. Serious injury can
occur.
Risk of injection or
injury to person.
DO NOT direct discharge stream
toward persons.
For high pressure operation, pull back
the nozzle of the multi-adjustable
spray wand as shown.
The nozzle at the end of the multi-
adjustable spray wand can be rotated
to change the high pressure spray
pattern from a 0º pencil stream to a
40º fan spray, as shown. Markings
have been placed on the nozzle to
help you select the spray pattern.
For low pressure operation, extend
the nozzle of the multi-adjustable
spray wand as shown.
PRESSURE WASHER
OPERATING FEATURES
PRESSURE ADJUSTMENTS
The pressure setting is preset at the
factory to achieve optimum pressure
and cleaning. If you need to lower the
pressure, it can be accomplished by
these methods.
1. Back away from the surface to
be cleaned.
The further away you
are, the less the pressure will be on
the surface to be cleaned.
2. Rotate the nozzle at the end of
the multi-adjustable spray wand
to widen the fan spray.
The wider
fan spray will minimize the pressure
on the surface to be cleaned.
DO NOT attempt
to increase pump
pressure. A higher pressure setting
than the factory set pressure may
damage pump.
3. Reduce the speed of the
gasoline engine (RPM).
Slow
the engine down and the water
pressure will go down with it.
Bypass Mode:
Allows water to
re-circulate within pump when the gun
trigger is not pulled.
Allowing the unit to
run for more than
two minutes without the gun trigger
pulled could cause overheating and
damage to the pump.
Thermal Relief Valve:
When the temperature
inside the pump rises
too high the valve will
open and release a
gush of water in an
effort to lower the
temperature inside the
pump. The valve will then close.
Chemical Injection System:
Mixes
cleaners or cleaning solvents with
the water to improve cleaning
effectiveness.
Water Supply:
All pressure washers
must have a source of water. The
minimum requirements for a water
supply are 20 PSI and 5 gallons per
minute.
Low
Pressure
High
Pressure
40º fan spray
0º pencil stream
Thermal
Relief Valve