10- ENG
A11756
STARTING
Prior to starting, refer to your engine
manual for proper starting procedure.
1. In a well ventilated outdoor
area
add fresh, high quality,
unleaded gasoline with a pump
octane rating of 86 or higher. Do
not overfill. Wipe up spilled fuel
before starting the engine. Refer
to Engine Owners Manual for
correct procedure.
2. Check engine oil level.
See
Engine Owners Manual for correct
procedure.
3. Verify
the filter
screen
is in
water inlet
of pump.
NOTE:
Cone side
faces out.
4. Connect
water source to pump inlet.
NOTE:
Water source must provide
a minimum of 5 gallons per minute
at 20 PSI.
5. Connect
high pressure hose to
pump outlet.
6. If applying a chemical or
cleaning solution
, see How
To Apply Chemicals/Cleaning
Solvents instructions in this
section.
7. Turn water source on.
NOTE:
Failure to do so could
cause damage to the pump.
HOW TO APPLY CHEMICALS
AND CLEANING SOLVENTS
Applying chemicals or cleaning
solvents is a low pressure operation.
NOTE:
Use only soaps and chemicals
designed for pressure washer use.
Do
not use bleach.
To Apply chemicals:
1. Press chemical
hose
onto barbed
fitting located
near high pressure
hose connection
of pump as
shown.
2. Place other end
of chemical
hose with filter on it into container
holding chemical/cleaning
solution.
NOTE:
For every 7
gallons of water pumped 1 gallon
of chemical/cleaning solution will
3. Set multi-adjustable nozzle
to
low pressure setting. See How
To Use Wand paragraph in this
section.
4. After use of chemicals,
place
chemical hose into container of
clean water and draw clean water
through chemical injection system
to rinse system thoroughly. If
chemicals remain in the pump
it could be damaged. Pumps
damaged due to chemicals will
not be covered under warranty.
NOTE:
Chemicals and soaps will not
siphon when spray wand is in the high
pressure setting.
Barb
Fitting
Water
Source
High
Pressure
Hose
Filter Screen