NL
FR
EN
32
ASSEMBLY
HOT AIR EVACUATION TUBE
When set to air-conditioning mode, the appliance must be placed close to a window or another opening for the hot air to be
evacuated outside.
First, place the unit onto a level area of floor and make sure that there is a distance of at least 45cm all the way around the
unit as well as a power socket nearby.
1 Unfold one end of the tube (Fig. 1) and screw it onto the tube input section (Fig. 2).
2 Unfold the other end of the tube and screw it onto the tube outlet section (Fig. 3).
3 Fit the tube input section onto the unit (Fig. 4).
Extend the side of hose
Lock
Slide in
4 Attach the tube exit section to the sliding window kit and seal it (Fig. 5 and 6).
Vertical window
Lock in place
Sliding section
Horizontal
window
Your sliding
necessary
screws.
NOTE: If the window you are using is shorter/narrower than the minimum length of the sliding window kit, you can cut it on
the side
INSTALLATION OF SLIDING WINDOW KIT
1. Assembly:
Slide panel A into panel B and adjust to the width of the window. Window sizes vary. When adjusting the width, ensure that
there are no gaps in the sliding window kit as you are taking measurements.
Manual_Snowair7C-9C-9CP-12C-12CP_2021.indd 32
Manual_Snowair7C-9C-9CP-12C-12CP_2021.indd 32
25/01/21 11:33
25/01/21 11:33