Design and function
MIG/MAG welding
34
099-005221-EW501
05.09.2016
5.3.3
Further welding parameters
NAVIGATION
B
A
A
A
A
A
A
B
B
B
B
ENTER
EXIT
3 s
l
0
Figure 5-15
Display
Setting/selection
Dynamic correction
• Increase value > harder arc
• Decrease value > softer arc
Gas pre-flow time
Gas post-flow time
Correct wire burn-back
If too high a value is set, a large ball will form at the tip of the wire electrode (bad re-
ignition) or the wire electrode sticks to the contact tip. If too low a value is set, the wire
electrode sticks to the weld pool.
• Increase value > increase wire burn-back
• Decrease value > decrease wire burn-back
Wire creep
Содержание Taurus 355 Basic TDM
Страница 5: ...Contents Notes on the use of these operating instructions 099 005221 EW501 05 09 2016 5 ...
Страница 17: ...Machine description quick overview Rear view 099 005221 EW501 05 09 2016 17 4 2 Rear view Figure 4 2 ...
Страница 59: ...Appendix B Overview of EWM branches 099 005221 EW501 05 09 2016 59 11 Appendix B 11 1 Overview of EWM branches ...
