Design and function
Scope of delivery
099-008808-EW501
12.04.2018
9
5
Design and function
CAUTION
Risk of accidents due to supply lines!
During transport, attached supply lines (mains leads, control cables, etc.) can cause
risks, e.g. by causing connected machines to tip over and injure persons!
• Disconnect all supply lines before transport!
Read and observe the documentation to all system and accessory components!
5.1
Scope of delivery
The delivery is checked and packaged carefully before dispatch, however it is not possible to exclude the
possibility of damage during transit.
Receiving inspection
• Check that the delivery is complete using the delivery note!
In the event of damage to the packaging
• Check the delivery for damage (visual inspection)!
In the event of complaints
If the delivery has been damaged during transport:
• Please contact the last haulier immediately!
• Keep the packaging (for possible checking by the haulier or for the return shipment).
Packaging for returns
If possible, please use the original packaging and the original packaging material. If you have any queries
on packaging and protection during transport, please contact your supplier.
5.1.1
Ambient conditions
Equipment damage due to contamination!
Unusually high amounts of dust, acids, corrosive gases or substances can damage the machine
(observe maintenance intervals > see 6 chapter).
• Avoid large amounts of smoke, steam, oily fumes, grinding dust and corrosive ambient air!
5.1.1.1
In operation
Temperature range of the ambient air:
• -25 °C to +40 °C (-13 F to 104 F)
Relative humidity:
• up to 50 % at 40 °C (104 F)
• up to 90 % at 20 °C (68 F)
5.1.1.2
Transport and storage
Storage in a closed room, temperature range of the ambient air:
• -30 °C to +70 °C (-22 F to 158 F)
Relative humidity
• up to 90 % at 20 °C (68 F)
5.2
Establishing the connections
Damage to the machine due to improper connection!
The remote controls have been developed to be connected to welding machines or wire feed
units only. Connecting them to other machines may cause damage to the machines!
• Observe the operating instructions for the welding machine or wire feed unit!
• Switch off the welding machine before connecting!
• Switch off the welding machine.
• Insert the male connector plug (socket) into the remote control connection socket and lock by turning
to the right.
• Insert the male connector plug (pin) into the remote control connection socket of the welding machine
and lock by turning to the right.
