Design and function
Electrode replacement
16
099-002025-EW501
29.11.2017
Observe the following order:
• From the rear, screw the electrode guide insert into the torch body.
• Insert the compensating spring.
• Screw in the collet body as far as it goes.
• Insert the collet chuck with the tungsten electrode.
• From the front, screw the setting gauge into the plasma nozzle thread as far as it goes so as to place
the tungsten electrode into the correct position.
• Screw the back cap into the threaded intermediate piece.
• Unscrew the setting gauge.
• From the front, insert the ceramic insert tube.
• Firmly screw in the plasma nozzle.
• Screw on the gas nozzle.
You can optimise the plasma jet at a later stage using the collet body. This way, you can slightly
change the position of the tungsten electrode.
