Gently slide a screwdriver into the
bottom edge of the badge. Gently turn
the screwdriver counter clockwise. The
badge is held on by a magnet in the well
of the battery door. The badge should pry
off easily.
DO NOT USE FORCE.
About The Badge
All of our thermostats use the same universal magnetic badge. Visit the
company website to learn more about our free private label program.
Private Label Badge
Installation Tips
When performing an attic installation, instead of placing the base
module in the attic, locate the closet nearest to the air conditioning
unit. Then mount the base module high on the wall inside the closet or
on the ceiling of the closet. This location will insure the base module is
below the 150°F maximum ambient temperature specification.
Installation Tips
Do not install the base module in locations:
• That are behind a chimney
• Where temperature could exceed 150°F
• Where rain or snow or extreme hot or cold is possible
Note: This base module is NOT weatherproof.
Installation Tips
_ b q q b o
k l
d l l a
_ b q q b o
Base Module - Basement Location
Range between the thermostat and the base module is up to 100 feet
with no obstructions and approximately 50 feet in standard residential
construction. To extend the range try replacing the base unit higher if
in a basement or further away from large metal objects.
Wireless Range
Installation Tips
Do not install the base module in locations:
• That are behind a chimney
• Where temperature could exceed 150°F
• Where rain or snow or extreme hot or cold is possible
Note: This base module is NOT weatherproof.
Wireless Communication Tips
Follow these steps for a simple wireless communication setup.
Locate all components in
area near equipment.
Wire base module with 8ft
pigtail and temporarily mount.
If you are not able to establish
communication, this will allow
you to relocate the module to
an area with less obstruction,
without having to rewire.
Install batteries in all devices
you wish to use.
Thermostat, indoor/outdoor sensors.
A.
Press the menu button
on thermostat
B.
Press & hold tech set up button
C.
Configure the set up for
your application
D.
Establish communication between devices
Install thermostat in final location.
Note: You must hardwire the thermostat when using remotes.
Turn on fan from thermostat to ensure communication.
Once communication is established, permanently mount module.
If there is no communication between the thermostat and base
module devices that are less than 50ft. apart, utilize an 8ft. pigtail to
relocate and reduce interference. If there is not communication and
devices are over 50ft. apart, add a W150W - Wireless Repeater.
Troubleshooting
l m q f l k =
P
l m q f l k =
N
l m q f l k =
O
Magnet in door
Use the bevel on lower ridge
Temperature
Set Time
Next Zone
Clean
Display
Humidity
Living space
closet
Living space
Attic
Good
Clean
UPSTAIRS
Clean
UPSTAIRS
H
D
Y1
Y2
W1/E
Pro1 Base Module
for use with T955WH
W2
G
O
B
