Cleaning the UV-C Sterilising Lamp
Cleaning the UV-C Sterilising Lamp
Ensure the Raycop is unplugged from the mains
Undo the locking screws on each of the lamp grills using a
cross head screw driver, unclip the grills and lift out (fig. 5).
Use the dust cloth provided to clean and polish the
UV-C Lamp glass cover (fig. 6).
Reposition the grill and clip back in place then tighten each
locking screw.
We suggest that the UV-C Lamp should be replaced every
2 or 3 years if used as stated in these instructions.
Replacing the UV-C Sterilising Lamp
Replacing the UV-C Sterilising Lamp
Ensure the Raycop is unplugged from the mains before
replacing the UV-C Lamp.
Undo the 7 screws using a cross head screw driver on the
UV-C Lamp housing (fig. 7).
Remove the housing (fig. 8).
Grip one end of the UV-C Lamp on the metal surface with a
pair of small pliers and rotate by 90 degrees until theUV-C
Lamp pins line up with the slot. Lift the UV-C Lamp out off
the base (fig. 9).
Place the new UV-C Lamp into the protective tube and
reposition into the base (fig. 10).
Rotate the UV-C Lamp through 90 degrees using a small
pair of pliers (fig. 11).
Replace the lamp grill and tighten all 7 screws (fig. 12).
Plug in the product press
ON/OFF this will turn the unit on.
A light will appear the above
, you will need to reset the
unit using the tip of a pen above the symbol
Press
pause
menu and select option 1 or 2 you
should see the UV-C Lamp through the window on the top
of the product.
46
5
6
7
Undo the
7 screws
Clean &
polish UV-C
Lamp glass
cover
Remove the
grill
Remove the
housing
Remove /
Replace
UV-C Lamp
from tube
8
11
12
Rotate
Lamp
through 90
º
and remove
Replace the
grill and 7
screws
Relocate
new UV-C
Lamp and
tube
9
10
RAYCOP MANUAL MULTI 7 languages.QXD:RAYCOP MANUALMULTI.QXD 26/2/08 09:50 Page 47
