Installation Manual MK-Series
3/10
Installation should be done only by qualified installers and conform to all local codes.
It is the users’ responsibility to ensure that the mounting methods are safe and adequate for
the location.
Use only A4 quality stainless steel hardware to fasten the mount to an outdoor surface.
All servicing should be performed by qualified service personnel. Procedures in this manual
do not require entry into the housing of the camera positioning system. The unit contains
potential high voltage. It also contains sensitive devices that can be damaged by static
discharge. To reduce the risk of electric shock and damage to the unit by static discharge do
not perform any servicing other that described in these instructions. If the unit is defective,
please contact the Customer Service Department for technical assistance.
Liability: It is the sole responsibility of the installer to provide proper installation in compliance
with all local codes and regulations.
WARNING:
Do not remove covers. There are no user-serviceable parts inside.
CAUTION:
Mount the camera system before the power is applied. After the power is applied the camera system
will start a configuration sequence and pan and tilt movement will occur.
17XXHD
WARNING:
Power supplies used with these cameras operate on 115 Vac or 230 Vac. These voltages are
dangerous. Use extreme care working with equipment connected to either 115 Vac or 230 Vac.
IMPORTANT!
If the camera needs to be shipped, please use the original packaging material which was designed
to protect the product during transportation. If the original packaging is lost or damaged, please
order a replacement at ELR.
SAFETY INSTRUCTIONS
