EVS Neuron NFR2000, Инструкция по установке и обслуживанию

Страница: 20 / 30

3.4. Processing Module Installation and
Replacement
To insert the processing module into an NFR2000 frame, you should first determine whether the frame is
built as a datacenter version (connections on the front) or a broadcast version (connections on the
back). Once this is determined, slide in the processing module from the connector side until it cannot be
pressed any further. Make sure both sides of the card are following the glides so the card is guided
exactly into the frame’s internal bus connector. Push the card firmly into the internal bus. Then screw the
two lock screws, indicated in the picture below in red, firmly into the frame.
If a module slot remains empty, the empty slot should be fitted with a blind panel.
3.5. Power Supply Installation and
Replacement
Installing or Replacing the Power Supply in an NFR2000
The NFR2000 has redundant power supplies. Servicing one of the power
supplies requires disconnecting the corresponding power supply cable. To
reduce the risk of electric shock, disconnect both power supply cables
before servicing! This will cause the Neuron frame to shut down.
Le châssis NFR2000 est équipé d'alimentations redondées. L'entretien
d'une des alimentations nécessite de déconnecter le câble d'alimentation
correspondant. Pour réduire les risques d'électrocution, débrancher les
deux câbles d'alimentation avant tout entretien ! Ceci entraînera l'arret
complet du châssis Neuron.
8 | March 2022 | Issue 4.1.G