1a
1b
2
3
Selecting the mounting location
The controller is for internal use only.
Mount approx. 1.5 metres above the floor on an inner wall. Select the wall for ease of
wiring to the fan.
Avoid locations which are not generally affected by changes in the room temperature.
Do not mount on hot surfaces or surfaces exposed to direct sunlight.
Do not install in damp or wet areas like the laundry or bathrooms.
•
•
•
•
•
Open the thermostat by pushing in the tabs located on the bottom of the unit
(figure 1a and 1b)
and remove the interconnect cable.
Choose a mounting position on the wall and cut a 64 mm diameter hole in the
wall gib, avoiding any structure timber framing.
See
Wiring Diagrams
(figure 4a and 4b)
for connections.
After connecting the required wiring, mount the base of the controller with the 4
screws provided
(figure 2)
, noting the top direction.
Reconnect the interconnect cable to the display front.
Replace the cover by locating the two tabs at the top of the unit and lever the
touch screen on as shown
(figure 3)
. As you close the unit ensure the two plastic
tabs at the bottom clip into place.
1.
2.
3.
4.
5.
6.
Note: Do not use excessive force to fit the cover.
Mounting Instructions & Installation
EVOAQ EC Fan (side)
RJ45 Connector
EVOAQ EC Fan (front)
Page 3
V1.1:20181005
