9
Assembly
Disconnect the power plug before carrying out any adjustments or maintenance.
Installing a saw blade
1. Press the spindle lock lever (12) positioned near the front handle and rotate the blade until it
locks.
2. Use the wrench clockwise to unscrew the central fixing screw.
3. Remove the outer flange, lift disc guard and remove the disc
4. Clean the disc guard from debris.Put disc back into place so that the arrow direction from disc
to be the same as the rotation direction of the power tool. Assemble the parts in reverse order.
Lock the spindle acting (12) and make sure the screw is tight.
Adjusting bevel cutting angle
To adjust the bevel cutting angle between 0
– 45 degrees, loose angle adjust wing nut (8) and
move the base plate to the desired angle, according to bevel scale. Tighten wing nut.
Adjusting the depth of cut
To adjust the cutting depth, move the lever (9) upwards, adjust
the desired cutting depth, and then return to the initial position by
pressing down the lever lever for clamping and clamping.
Fixing guide rule
Slide the guide rule into the base plate and tighten screw
(7).
Operation
WARNING! In case of any abnormal noise,
immediately turn off the tool and contact an
authorized service facility for repairs
Use the appropriate type of blade for the material you are cutting.Do not use
damage blades
DO NOT USE SPEED STEEL BLADES!
1.
Set the cutting angle and depth of cut and position the rail guide parallel to the edge of the
workpiece.
2.
Hold powertool firmly by both hands and keep fingers away from the saw blade.
3.
Start powertool by pressing lock button (3) and switch (2), before the saw blade touches the
material.
4.
With the saw at full speed, move the saw slowly forward to complete the cut.
