©2009 Evolved Sonic Solutions, LLC
©2009 Evolved Sonic Solutions, LLC
Troubleshooting
No wireless connection
1. Make sure both the transmitter and amplifier are operating on the same
house code.
2. Make sure receiver is within the broadcast range of the transmitter.
Wireless Connection, but no sound
1. Make sure the audio source is properly connected, analog line level L/R
(1 Vrms max)
2. Verify Transmitter and Amplifier are operating on the same House Code.
Evolved Sonic Solutions LLC
Corporate Address:
P.O. Box 310162
New Braunfels, Texas 78131 USA
T: +1 (888) 814-4440 evolvedsonic.com
Copyright and Trademark Information
All Copyrights and Trademarks are the property of their respective owners.
Evolved Sonic Solutions LLC does not make or imply any connection or
endorsement from any third parties.
Operational Configurations
Stereo - Basic Set-up, connect to appropriate line level analog source.
Hi-Fi Mono Block
Use 1 ES2 ADW amplifier on each monitor, see Bi-Amp set-up instruction. Program
the Left monitor amplifier to operate in the “LEFT” mode, see Programming section.
Program the Right monitor amplifier to operate in the “RIGHT” mode.
Wireless link Surround Back Channels of Home Theater System - Connect ES2 Stream
2 Transmitter to the Pre-Amp output for the Surround L/R. A second Transmitter
can be connected to the Surround Rear L/R channels as well by using a different
Housecode on the Transmitter and Amplifier, See Multi-Zone Set-Up section.
Commercial/Distributed
Connect the ES2 Stream 2 Transmitter to the desired analog line level source.
Program each ES2 ADW Amplifier to operate in the MONO/MONO mode. This will
enable a fully expandable sound system to operate within range of the Transmitter.
Multi Zone
The ES2 Stream 2 system permits up to 3 unique zones within a common RF
coverage area, see Creating Multiple Zones section.
Creating Multiple Zones
ES2 Stream 2 System is capable of supporting three independent audio networks
within a common broadcast zone. Thus three different audio sources can be utilized
in the same common area. The Stream 2 ADW Amplifiers can be selected to link with
any of the three sources.
The default setting is both the Stream 2 Transmitter and ADW Amplifier is in House
Code 1. Changing the House Code is accomplished through the “LINK” button
located on the bottom of the ES2 Transmitter and ADW Amplifier. Pressing the “LINK”
button sequentially steps the House Code with each press:
HINT:
If setting up single transmitter, amplifier pair, establish power on link. Then step the
house codes on both the transmitter and amplifier, re-establishing the link with each
press.
If setting up single transmitter to multiple amplifiers, step the transmitter to the desired
house code. then step each amplifier until it has established a link with transmitter.
14
15
