Evolve Customer Support available at 856/552-4000, 888/827-2500, from 8:30 Eastern through 6 Eastern time, or fax at 856/552-4001.
Installation Manual – January 2001
5
P
anels
Note
: Any alterations to listed components will void the manufacturer's warranty. The manufacturer will
not be responsible for any damage or bodily harm caused by alterations in accordance with national or
local electrical codes and manufacturer's specifications.
In accordance with the manufacturer's policy of continual product improvement, the product presented in
this document is subject to change without notice or obligation.
Panels
Installation Instructions
Inline Connection – Equal Height
(EVPIC)
Parts List
:
1 Slotted post with levelling glide
1 Double clamp
The Inline Connector is used to connect two panels of equal height in a
straight line.
1. Remove the panel top caps.
2.
Partially attach the slotted post to one end of the panel to be
installed
by engaging the down-hook at the bottom of the panel
(above the raceway channel) over the up-hook on the slotted post.
3.
Attach the opposite end of this panel to the slotted post of the
run of panels.
Do this by engaging the down-hook at the bottom of
the panel (above the raceway channel) over the up-hook on the
opposite side slotted post.
4.
Connect the two panels and Inline Connector
by engaging the
double clamp through the slotted post and into the panel liner.
Secure the double clamp by bolting it to the top of the panel using
four (4) 1/2" flat head screws.
5.
Reattach the panel top caps
.
3
2
1
4
5