Evolution RAGE3+, Инструкция по сборке

Страница: 14 / 92

UNLATCHING & RAISING THE CUTTING HEAD
Ensure the Cutting Head is in its upper position, by pulling
out the Head Latching Pin whilst holding the cutting head
handle
(1. Fig. 15)
, allowing the Head to rise slowly to its upper
position
(2. Fig. 15)
. More instruction on this can be found
in the ‘Original Instruction Manual’, in the section titled
‘Unlatching & Raising The Cutting Head’.
FITTING THE BLADE
WARNING:
Only carry out this operation with the machine
disconnected from the mains supply.
WARNING:
Only fit the blade after the assembly process and
the Assembly Safety Checks are completed.
See Assembly Safety Checks list on page 16.
Note:
It is recommended that the operator wears protective
gloves when handling the blade during installation or when
changing the machines blade.
WARNING:
Only use genuine Evolution blades or those blades
specifically recommended by Evolution Power Tools and which
are designed for this machine. Ensure that the maximum speed
of the blade is higher than the speed of the machine’s motor.
Note:
Blade Bore Reducing Inserts should only be used
in accordance with the manufacturers instructions.
WARNING:
The arbor screw has a LH thread. Turn clockwise to
loosen. Turn counterclockwise to tighten.
Press & keep pressing the arbor lock button on the motor housing
while turning the arbor screw using the supplied Hex Key until the
button locates fully into the shaft and locks the shaft
(Fig. 16)
and
continue to remove the arbor screw, washer and outer blade
flange.
(Fig. 17)
Release the arbor lock button.
Fig. 15
1. PULL-OUT
HEAD LATCHING
PIN
2. HEAD RISES
SIDE OF MACHINE
Fig. 16
Fig. 17
14
www.evolutionpowertools.com