6
www.evolutionbuild.com
CaRRYInG YOUR MITRe saW
1. Although compact, this saw is heavy. To reduce the risk
of back injury, get competent help whenever you have to
lift the saw.
2. To reduce the risk of back injury, hold the tool close to your
body when lifting. Bending your knees so you can lift with
your legs, not your back. Lift by using the handhold areas at
each side of the machines base.
3. Never carry the mitre saw by the power cord or the trigger
grip of the handle. Carrying the tool by the power cord could
cause damage to the insulation or the wire connections
resulting in electric shock or fire.
4. Before moving the saw tighten the slide lock knob to
guard against sudden movement.
WaRnInG:
Do not use the blade guard as a
‘lifting point’.
The power cord must be removed from the power supply
before attempting to move the machine.
• Lock down the head using the head locking pin.
• Move the cutting head to its outermost position and lock in
place by tightening the slide lock knob.
• Loosen the mitre angle lock knob. Pull up the mitre angle
lever and rotate the table to either of its maximum settings.
• Lock the table in position using the locking knob.
• Use the two carry handle cut-outs machined into either
side of the machine base, to transport the machine.
Place the saw on a secure stationary work surface and check
the saw over carefully. Check particularly the operation of all
the machines safety features before attempting to operate
the machine.
WaRnInG:
Do not operate machine if warning
and / or instruction labels are missing or damaged. Contact
Evolution Power Tools for replacement labels.
symbol
Description
V
Volts
A
Amperes
Hz
Hertz
Min
-1
Speed
~
Alternating Current
n
o
No Load Speed
Double Insulated
Wear Safety
Goggles
Wear Ear Protection
European Conformity
Euuropean Directive for Restriction
of Hazardous Substances.
Read Instructions
Wear Dust Mask
Only use genuine evolution replacement blades.
Unauthorised blades may be dangerous! Keep saw blades
securely fastened. Check blade flanges for debris before
installing any new blade. Do not use dull or broken blades.
Check blades often for condition and wear. Damaged or worn
blades should be replaced immediately. Check chip collector
cover for proper fit to minimize the risk of flying debris. Loose
fitting or damaged collector must be replaced immediately.
Beware of ejecting chips as they may be HOT. Always make
provisions for safe handling of excess material. Keep bottom
of base plate free from dirt and other debris.
To obtain an additional copy of your manual, please
contact evolution Power Tools at :
UK
0870 609 2297
Usa
1-866-EVO-TOOL
WeB
www.evolutionpowertools.com
®
laBels & sYMBOls
GB