Evolution Rage3-B, Оригинальное руководство пользователя, Страница: 20 / 152

20
www.evolutionpowertools.com
Fig. 7
Fig. 8
Fig. 9
BEVEL ANGLES (0
0
AND 45
0
)
0
0
Bevel Stop Adjustment
• Ensure that the Cutting Head is in the locked down position
with the latching pin fully engaged in its socket.
(see Fig.15)
• Ensure that the Cutting Head is upright, against its stop and
the bevel pointer is indicating 0
0
on the scale.
(Fig. 7)
• Place the Set Square on the table with one short edge
against the table and the other short edge against the blade
(avoiding the TCT tips).
(Fig. 8)
• If the blade is blade is not 90
0
square with the mitre table
adjustment is required.
• Loosen the Bevel Lock Handle and tilt the Cutting Head
to the left.
• Loosen the locknut on the Bevel Angle Adjustment Screw.
(Fig. 9)
• Use a Hex Key to turn the screw in or out to adjust the
blade angle.
• Return the Cutting Head to its upright position and recheck
the angular alignment against the Set Square.
• Repeat the above steps until correct angular
alignment is achieved.
• Tighten the Bevel Angle Adjustment locknut securely.