Wires should
face the
control box.
Wires should
face the
control box.
5. Using the 5mm allen key, screw the 3 fixing
inserts into the holes you have drilled in the
body of the Nexus. Tighten inserts until flush
with the surface.
7. With the foam seal fitted, re-fit the inlet slide plate
assembly, again using a sash clamp if needed.
8. Using the 3mm allen key, screw the 3 hex socket
screws into the fixing inserts and tighten up.
6. Ensure all edges of the inlet valve assembly are
completely dry. Peel off the backing tape from the
foam seal, then proceed to fit the foam seal around
edge of the outer blade on inlet valve assembly.
The seal must be centrally aligned. Trim off any
excess length.
Seal
Edge
11
View from
inside
the Eazy.
View from
inside
the Eazy.
Nexus name
plate on this
side of Nexus.
Nexus name
plate on this
side of Nexus.
View from
inside
the Eazy.
Nexus name
plate on this
side of Nexus.
