11
EvoHeat CS-i Commercial Inverter Series Heat Pump
No.
Name
Colour
Function
1
Timing silent off
Used: Red
Unused: Grey
Click to use or unused timing off function
2
Timing silent on
Used: Green
Unused: Grey
Click to use or unused timing silent function
3
Timing silent start time
Click this button to set the timing silent start time
4
Timing silent end time
Click this button to set the timing silent end time
The start and end time values me be within the range of 0:00 – 23:00; the value can be precise to the hour digit.
Example: Click ‘ON’ to use timing silent. The unit will begin silent mode from 0:00 and end at 4:00. Click ‘OFF’ to turn
off the timing silent manually, however the unit will turn off this setting once it reaches the end time.
5.2.5 Fault History
To view the fault records, press (4).
If there is no failure, the main interface will display a static “
”
When a fault occurs, the fault icon will flash. When this occurs, the failure
interface will record the time, code and name of the fault.
After troubleshooting, if you do not check the failure record, the main
interface will display a static symbol: “
“
If you check the failure record, the main interface will display a static: “
”
The failure record is in reverse order according to the time of occurrence. Press the clean key to delete all fault
records.
5.2.6 Colour Display Calibration
Keep clicking quickly on the blank area at any interface until you hear a long beep. You will then enter the calibration
interface. Click “+” to start calibration. When you hear the beep again, you will finish calibration and exit.
Note: The wire controller can display the temperature unit as ‘°F’ or ‘°C’ according to the model you bought.
5.2.7 Temperature Curve
Press the TEMP CURVE (7) button to view the
temperature curve & average power curve.
The temperature curve automatically updates every hour
and will be stored for 60 days.
If the unit is powered off after less than 1 hour of operation, the data in this period will not be saved.
5.2.8 Boost Mode
The CSi system is capable of operating in high output Boost mode to assist in
reaching the desired target temperature faster.
You can activate boost mode by simply pressing the “Boost” button in the
display.
When the target water temperature is reached, the system will automatically
deactivate Boost mode and retrain to normal operation.
Alternatively, Boost mode can be manually deactivated by simply pressing the
“Boost” button again to turn it off.
